Whirlpool is now by far the largest company of home appliances. Your past successes are proof of their experience in the production of appliances to be reliable. However, they are not entirely foolproof.
If you have a hot tub washing machine owner, I'm sure you've had some problems with its functions. Certain models of Whirlpool has received negative reviews.
But most modern washing machines easily broken. Because of constant use, wear andcrack, break worse parts of the machine and down. He wants to know the common problems of the hot tub washing machine, so you can easily use the right solution for them.
1 The disc stops unexpectedly and you receive an error-LF.
LF stands for Long Fill. Modern washing machines must be filled with water at the time, but you will get this error. You should check the water pressure in your area. If low, adjust the pressure. Also check the filter of the machine.Debris can hamper the flow of water. Clean the filter.
Check the donor as well. The water will flow in the dispenser. If the water does not flow well into the delivery, control of water intake screens on the back of the disc found. Turn off the water source and remove the tube. Remove the panel covering the screen. Get rid of accumulated dirt in these areas.
2 He stops at the water overflows.
This usually happens in windows or convertible. This is probably caused by damagePressure sensor. This part is connected to the control board of the machine. If it is damaged, do not tell the machine to turn off the water source, if the drum has been filled. You may need to be fixed if it is still under warranty.
3 The water from the cold / cool water is warm setting.
Perhaps you've changed the combination of hot and cold water valve. Make sure you do it well. Check the manual that the washer and find out whereYou can use the hot water valve and cold water valve. Once connected, you give him a little test.
4 Do not turn.
If you can see the code F51 and the machine is in operation, is probably due to a faulty switch in the rotor position of the washer. This is a communication problem between the sensor and the motherboard to not only replace the motherboard.
Find out if there are any loose wires connected to switches of the rotor. If you absolutely will not work,You may need to buy a kit to replace the switch, and the rotor position.
0 comments:
Post a Comment